What to do if my SATO CG4 Printer cover is open?
If you receive a 'Cover open' error on your SATO Printer, it indicates that the cover is not closed properly. Make sure to close the cover completely.
Why is my SATO CG4 printing very dark?
If your SATO Printer's print is very dark, set the print darkness.
What to do if my SATO Printer is not turning on?
If your SATO Printer is not turning on: Check the connection of power connector Check the connector connection Check the connection of Main PCB board and KB board SET.
What to do if my SATO Printer cutter does not move?
If the cutter on your SATO Printer does not move: Set to Cutter Mode Press the FEED/LINE button to move cutter blade to its home position Clean the cutter blade.
General| Print Method | Thermal transfer |
|---|---|
| Print Resolution | 203 dpi |
| Print Width | 104 mm |
| Media Type | Label, tag |
| Media Width | 25.4 mm to 114 mm |
| Media Thickness | 0.06 mm to 0.19 mm |
| Media Roll Diameter | 127 mm |
| Processor | 32-bit RISC |
| Memory | 8 MB Flash |
| Interfaces | USB, Serial |
| Optional Interfaces | Wireless |
| Power Source | 100-240 VAC, 50/60 Hz |
| Roll Core Inner Diameter | 25.4 mm |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Print Speed | 4 ips (101.6 mm/s) |
| Ribbon Core | 25.4 mm |
| Humidity | 20% to 85% (non-condensing) |
To Next Page
