SATO CL608e/CL612e - 6.11 Replacing the Paper End Switch (Micro-Switch) and the Bottom Half of the Notch;Gap and Eye-Mark Sensors

Page 6-30
Section 6. Replacement Procedures
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
6.11 Replacing the Paper End Switch (Micro-Switch) and the
Bottom Half of the Notch/Gap and Eye-Mark Sensors
MEDIA HOLD DOWN COVER
(SHOWN IN RAISED POSITION)
CONTAINS THE TOP HALF OF
THE NOTCH/GAP SENSOR
NOTCH/GAP SENSOR
(TOP HALF)
NOTCH/GAP SENSOR
(BOTTOM HALF)
PAPER END SWITCH
(MICRO-SWITCH)
EYE-MARK
SENSOR
SENSOR LOCATIONS
Fig. 6-57
Fig. 6-56
REMOVE THE
RIBBON AND
LABEL STOCK