SATO CL612e - Section 6. Replacement Procedures; Overview

Page 6-1
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
Replacement Procedures
6.1 Overview
6
Section
SATO CL608e/CL612e Printers contain replaceable components and sub-
assemblies. This section contains step-by-step instructions for removing and
replacing the following components and sub-assemblies.
· Main Circuit Board
· Fuse(s)
· Power Supply
· Stepper Motor
· Timing Belts
· Print Head
· Platen
· Ribbon Drive Clutch Washers
· Ribbon Motion Sensor
· Paper End Switch
· Notch/Gap & Eye-Mark Switch
· Display Panel & Keyboard