SATO CL612e - Page 180

Page 9-8
Section 9. Optional Accessories
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
Label Dispenser Installation
STEP PROCEDURE
1. Switch the printer OFF.
2. Remove (3) screws holding the left side cover to the printer. Raise the access
door and loosen the (2) screws on the inside top of the printer. Lift off the
left side cover. Figs. 9-9
3. Remove the ribbon and label stock if installed.
REMOVE (3) SCREWS
Figs. 9-9
RAISE THE ACCESS
DOOR AND LOOSEN
(2) SCREWS ON THE
INSIDE TOP OF THE
PRINTER
REMOVE RIBBON AND
LABEL STOCK