SATO CL6NX - Initial Printer Settings

12
Initial Printer Settings
To print the PDF data properly, you need to perform the following initial printer settings:
1. Make sure that the PDF direct print mode is enabled.
Once the PDF Direct Print firmware is installed on the printer, the direct print mode is enabled by
default.
The DP (Direct Print) status icon is shown on the status bar at the top of the display.
If the DP status icon is not shown, you can enable the direct print mode in the [Settings] >
[Applications] > [DIRECT PRINT] menu. Select [Enable] to show the [Enable] menu and select
[Enabled].