Section 2: Accessories Installation
Page 2-2 PN 9001110A SATO CX400 Service Manual
Cutter Installation, Figure 2-1
15. Insert power switch (8) into its respective slot of housing (9) oriented with the on position
upward.
16. Plug cutter assembly lead (13) into external connector (14).
17. Manipulate cutter assembly (15) into the face of printer chassis (16).
18. Secure cutter assembly (15) to printer chassis (16) by applying screw (17) to their upper
right corner.
NOTE: When properly installed, the tab of the cutter assembly
bracket shall insert into the slot of the printer chassis and the cutter
will nest there as the peeler cover prior to removal.
19. Ensure print media and ribbon are properly loaded in the printer.
20. Lower the print assembly and latch in position.
21. Close cover, connect power supply cord, and apply power.
22. Send the following command stream to enable: <ESC>A <ESC>CK1 <ESC>Z.
7
1
4
3
2
1
5
6
To Next Page
Loading...
