Section 3: Operation
Page 3-2 PN 9001110A SATO CX400 Service Manual
Media Loading, Figure 3-1
RIBBON LOADING
Perform the following procedure only if thermal transfer printing is desired. If thermal transfer
printing is desired, program the printer accordingly. Refer to the Programming Manual for
guidance.
1. Lift cover (Figure 3-2, 1) to expose print assembly (2).
2. Simultaneously, press the two purple buttons (3) located on the top side of print assembly
(2) and pivot upward.
3. Place ribbon roll (4) between ribbon supply spindles (5) so that the coated side is oriented
outward.
NOTE: The coated side has the duller sheen. If still unsure,
scratch each side to determine which is coated.
NOTE: The ribbon supply spindle is located on the lower
side of the print assembly.
M
E
D
I
A
4
1
2
3
5
To Next Page
Loading...
