Section 2: Accessories Installation
Page 2-4 PN 9001110A SATO CX400 Service Manual
Dispenser Installation, Figure 2-3
1. Turn off power and disconnect power supply cord.
2. Lift cover (1) to expose print assembly (2).
3. Simulataneously, press the two purple buttons located on the top side of print assembly (2)
and pivot upward.
4. Remove the two screws (3) securing cover (4) to cover hinge (5) and lift away.
5. Remove clips (6) and (7) from the left and right ends of roller shaft (8) respectively.
NOTE: Before removing the retaining clips from each end of the
roller shaft, it is advised that their orientation be observed and
noted.
16
10
4
3
2
1
5
14
15
4
REARVIEW
7
11
9
10
6
8
12
13
To Next Page
Loading...
