Section 4: Troubleshooting
SATO CX400 Service Manual PN 9001110A Page: 4-3
Self-Diagnosis Label, Figure 3-1
Media Sensor Used (7): Identifies which media sensor type has been selected for use.
The correct one must be selected by printer commands or
through the application software.
Print Mode (8): Identifies the print mode setting. TT = Thermal Transfer and DT
= Direct Thermal.
Last Label Tear-Off (9): Indicates whether the back-feed function is utilized for tearing
off printed labels.
Control Code Denifition (10): Displays the control code setting. Control codes affect the
commands and special controls.
Pitch Offset (11): The offset value affects the start print position in relation to the
label’s leading edge.
Cut Count (12): On board counter of the total cut sequences. Permits monitoring
of component life cycles.
Memory Slot 1 (13): Provides on board non-volatile flash memory for storing
graphics, font characters, etc. 512K bytes.
Memory Slot 2 (14): Optional on board non-volatile flash memory for storing
graphics, font characters, etc. 2M or 4M bytes.
To Next Page
Loading...
