Section 1: Introduction
Page 1-4 PN 9001110A SATO CX400 Service Manual
Connection Ports, Figure 1-3
Extension Connection Port Accessible from the front of the printer and is located
behind the face cover. Permits the connnection of optional
extension modules.
MONITORING SYSTEMS
Media Index Sensor Determines the print location upon the label by detecting a
label gap or eye mark and then stepping the media to the
print position.
Ribbon Sensor Allows the printer to continuously monitor the presence of
ribbon when operating in the thermal transfer mode.
Dispenser Sensor Monitors the presence of a label in the dispenser. When
the label is removed from the dispenser, the next label will
be prompted
Print Head Open Sensor Detects when the print assembly is not latched into the
print position.
CONNECTION PORTS
Extension Port
Serial Port
VAC Power Supply Port
Parallel Port
Rear View
Front View
To Next Page
Loading...
