Section 5: Interface Specifications
GT Series Operator’s Manual Page 5-33
5.17 PARALLEL INTERFACE SPECIFICATIONS (CENTRONICS)
The parallel interface of this printer conforms to Centronics standards.
Basic Specifications
Interface board
Connector Printer Amphenol (DDK) 57 to 40360 (Equivalent)
Cable Amphenol (DDK) 57 to 30360 (Equivalent)
Cable length Under 3 meters
Signal level High level : + 2.4 to + 5.0 V
Low level : - 0.0 to – 0.4 V
Communication settings
One item or Multi communication can be selected using DSW2-5.
DIPSW2-5 Set Range
ON Multi-reception
OFF One Item
Maximum Reception
buffer capacity
2.95Mbyte
Timing chart
To Next Page
Loading...
