Section 3: Configuration and Operation
Page 3-18 GT Series Operator’s Manual
3.9.4 Choosing Continuous or Tear Off Operation
With this setting, you can choose between continuous paper feed or
Tear Off operation. If a cutter or peeler has been installed correctly,
you will also see the DISPENSER and CUTTER settings. If the
printer supports linerless labels, you will also see a LINERLESS
option.
Press the buttons to select any one of the options. The
default setting is CONTINUOUS.
Press the ENTER button to confirm the setting and proceed to the
next screen.
3.9.5 Back feed Ope ration Settings
The printer can be set to apply or not apply a backfeed to the label
before or after printing each label.
Press the buttons to choose from AFTER, BEFORE or
NONE. The default setting is AFTER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
3.9.6 Configuring the Internal Winding Unit
The printer can be set to apply or not apply a backfeed to the label
before or after printing each label.
Press the / buttons to choose from AFTER, BEFORE or
NONE. The default setting is AFTER.
Press the ENTER button to confirm the setting and proceed to the
next screen.
To Next Page
Loading...
