INSTALLATION GUIDE
ii
TABLE OF CONTENTS, continued
4.5 Installation of the Suction Brake Unit ................................... 12
4.6 Installation of Web Guide/Connector Panel ......................... 13
CHAPTER 5. ELECTRO MECHANICAL SETUP PROCEDURE........... 15
5.1 Mounting the Paper Stopper (Stacker)................................ 15
5.2 Preparation of the Developer Unit....................................... 16
5.3 Controller Installation, Meto-Logic ...................................... 21
5.4 Storage of Test Print Samples............................................. 24
5.5 Power Cord Connection...................................................... 27
5.6 Main Power-On................................................................... 29
5.7 Controller Power-On ........................................................... 29
5.8 Entering Maintenance Mode............................................... 30
5.9 ATDC Adjustment ............................................................... 32
5.10 Toner Bottle Installation....................................................... 33
5.11 Power Off............................................................................ 35
5.12 Final Mechanical Check...................................................... 36
5.13 Leveling the Printer............................................................. 36
To Next Page
Loading...
