SATO LP 100R - Main Power-On; 5.7 Controller Power-On

INSTALLATION GUIDE
29
5.6 Main Power-On
1. Place the printer circuit breaker in the ON position, (Figure 5-21).
5.7 Controller Power-On
1. Turn the Printer's main Power switch On (see Figure 5-19).
2. Confirm that the Remote/Maintenance switch is set to Remote.
3. Toggle the Power On/Off switch on the Power Strip to the On position (see Figure 5-17).
4. To turn the Printer On, press the POWER LED switch (see Figure 5-23).
!
WARNING
!
Before connecting the Printer power cord, confirm that the Controller
power supply voltage selector switch is set to the 230V position.
Figure 5-21