INSTALLATION GUIDE
4
2.2 Removal of Packing Material and Accessories Boxes
1. Remove the two accessories boxes from the stacker tray.
2. Raise the stacker table upward.
3. Insert the ramp into the pallet on the front of the printer as shown in Figure 2-3.
Make sure that the ramp cannot separate from the pallet.
Figure 2-3
4. Adjust the printers leveling feet (4) upward from the base plate. Allow a minimum of 20mm of
clearance for the printer to move unobstructed down the ramp. (See Figure 2-4)
Figure 2-4
Ramp
To Next Page
Loading...
