INSTALLATION GUIDE
9
CHAPTER 3. Moving the Printer to the Operating Location
3.1 General Cautions
1. Use care not to damage the finish of the printer covers, especially while moving the printer through
door openings.
2. Do not tilt the printer more than 0.5 degree.
3. Do not drop the printer from a height exceeding 3 cm.
4. If the printer is moved on a “dolly,” make certain that it is entirely stable before moving.
5. If the printer is to be moved with a “fork lift,” use only the fork insertion position shown in Figure 3-1.
FORK INSERTION POSITION
3.2 After Moving
1. If no parts were removed for moving, proceed to paragraph 4.1, step 1.
2. If printer parts were removed for moving, replace all of the parts at this time.
Suction Brake
Figure 3-1
Fork Lift
Insertion Point
To Next Page
Loading...
