SATO LP 100R - Page 33

INSTALLATION GUIDE
19
5.2 Preparation of the Developer Unit, continued
7. Remove one of the developer powder boxes from accessories Box 2.
8. One at a time cut the corner of each packet and add the developer powder to the developer unit as
shown in Figure 5-9 and 5-10.
9. Evenly pour the contents of two packages of developer powder into the developer unit while rotating
the developer drive gear in the direction of the arrow as shown in Figure 5-10.
Figure 5-9 Figure 5-10
10. Re-install the developer unit lid.
11. Re-install the developer unit into the EP Drawer as shown in Figure 5-11.
Figure 5-11