SATO LP 100R - Page 45

INSTALLATION GUIDE
31
5.8.2 Turning the Printer's Power On, Continued
Note: After the warm-up sequence, the LCD display will boot to the Maintenance Mode Service
display, Figure 5-24. Because paper has not yet been loaded, an “FMU: FORM UNLOADED” error
message will appear on the bottom of the display. If forms had been loaded previously, and no
errors are present, the Maintenance Mode display will appear without an error message
(Figure 5-25).
Figure 5-24
Figure 5-25
IDLE
11.0" x 15.0"
600 dpi
LP 100R S/N: 10000000
I
SD
-
2
02VER1.5.19
0
1