A P P E N D I X D
D-1
LP 100R SWING GUIDE INSTALLATION
1.1 SWING GUIDE INSTALLATION PROCEDURE
Packing list
1 Swing guide assembly 1 5 Paper guide 2
2 Swing guide drive motor
assembly
1 6 Screw (4x8 mm) 11
3 Paper guide plate assembly 2 7 Cover (sensor) 1
4
Screw (3×5 mm)
14 8 Magnet assembly 1
Note: : • Lower the stacker table to the lowest position to facilitate the installation
work.
• Before starting the installation work, turn OFF the main POWER switch.
1. Open the front door, and remove the lower left
cover (black) by removing the four screws as
shown in Figure D-1.
Figure D-1
1
2
3 4
5
7 6
8
To Next Page
Loading...
