SATO M-8485Se - Error Signals

Sect ion 7. Troubleshooti n
g
ERROR SIGNALS
The LCD Display, Front Panel LED Indicators and Buzzer provide a
visual/audio indication of the t
yp
e of erro
r
encountered.
LED LCD
MESSAGE
AUDIBLE
BEEP
ERROR CONDITION TO CLEAR
Error On
Machine Error 1 Long Machine Error Cycle power on/off
Error On EEPROM Error
1 Long EEPROM Read/Write Cycle power on/off
Error On
Head Error 1 Long Head Cycle power on/off
Error On
Sensor Error 3 Short Sensor Cycle power on/off
Error Blinks Card R/W Error
1 Long Memory Card Read/Write Cycle power on/off
Error Blinks Card Low Battery
1 Long Memory Card Battery Low Cycle power on/off
Error Blinks Head Open 3 Short Head Open
Close head lever
Error Blinks
Cutter Error 3 Short Cutter Cycle Power On/Off
Error On
Line Blinks
Error On
Line Blinks
Error On
Line Blinks
Error On
Line Blinks
Error Blinks
Label On
Error Blinks
Ribbon On
Error Blinks
Label Blinks
Parit
y
Error 3 Short RS232 Parit
y
Error Cycle power on/off
Overrun Error 3 Short RS232 Overrun Error Cycle power on/off
Framing Error 3 Short RS232 Framing Error Cycle power on/off
Buffer Over 3 Short Buffer Overflow Cycle power on/off
Paper End 3 Short Label End Open/close Head Lever
Open/close Label Hold-
down
Ribbon End 3 Short Ribbon End Open/close Head Lever
Open/close Label Hold-
down
Media Error 3 Short Media Error Open/close Head Lever
Ribbon Blinks None Ribbon Near End Replace ribbon with full roll
Line Blinks None Buffer Near Full Slow down transmission
rate
SATO
“Se” Print En
g
ines Pa
g
e 7-7