SATO M-8485Se - LCD PANEL PRINTER CONFIGURATION

Section 3. Confi
g
uration
LCD PANEL PRINTER CONFIGURATION
The LCD Panel is used by the operator in conjunction with the LINE and FEED
switches to manually enter printer configuration settings. Many of these settings can
also be controlled via software commands and in the case of conflict between
software and control panel settings, the printer will always use the last valid setting. If
you load a label job that includes software settings and then enter a new setting via
the
LCD panel, the manually set values will be used by the printer. If you set the
values manually and then download a job with software settings, the software settings
will be used.
There are seven modes of operation. To enter the desired mode, the KEY SEQUENCE
combination listed in the table below must be performed. The initial LCD display
messa
g
e is shown fo
r
each mode.
MODE KEY SEQUENCE INITIAL DISPLAY PAGE
Normal POWER ONLINE
QTY:000000
A
dvanced LINE + POWER
A
DVANCED MODE
Test Print FEED + POWER TEST PRINT MODE
CONFIGURATION
Default Setting LINE + FEED + POWER DEFAULT SETTING
Y
ES NO
Clear Non-Standard Protocol DSW2-7 ON + LINE + FEED
+ POWER
A
LT. PROTOCOL
Protocol Code Download DSW2-7 ON + POWE
R
USER DOWNLOAD
Hex Dump of buffer DSW2-4 ON + POWER ONLINE
QTY:000000
SATO
“Se” Print En
g
ines Pa
g
e 3-9
Flash Download DSW2-6 ON FLASH DOWNLOAD
READY
DEFAULT COMPLETE
Boot Download DSW2-6 ON + FEED BOOT DOWNLOADER
+LINE + POWER PRESS FEED KEY
Hidden DSW2-4 ON + FEED HIDDEN MODE
+ POWER