SATO M-8485Se - Advanced Mode

Section 3. Confi
g
uration
ADVANCED MODE
An Advanced Mode is provided to make adjustments that require only occasional
changes. Since they affect the basic operation of the printer, the procedure for
entering this mode is designed to prevent someone from accidently changing the
settin
g
s.
ADVANCED MODE
The Advance Mode is entered by pressing the LINE key while
simultaneously turning power on. The printer will emit one long
beep after which the LINE key is released.
ZERO SLASH
Y
ES NO
AUTO ONLINE
Y
ES NO
This setting determines if a zero is printed with a slash or
without a slash. This setting can also be controlled via
software commands. When YES is selected (default), the
printer internal fonts will have a slash through the center of
the zero character.
1. Use the LINE key to step the cusor to either the YES or NO
selection.
2. Once the correct setting is selected, pressing the FEED key
will accept the setting and advance the display to the Auto
Online display.
This setting determines the mode in which the printer powers
up. If the YES selection is made, the printer powers up in the
ON LINE mode and is ready to print. If NO is selected, the
printer powers up in the OFF LINE mode and must be
manually placed in the
ON LINE mode by pressing the LINE
key before it is ready to print.
1. Use the LINE key to step the cursor to either the YES
(default) or NO selection.
2. Once the correct setting is selected, pressing the FEED key
will accept the setting and advance the display to the Print
Offset display.
SATO
“Se” Print En
g
ines Pa
g
e 3-13
DARKNESS RANGE
A
B
The Advance Mode is entered by pressing the LINE key while
simultaneously
turning
power
on.
The
printer
will
emit
one
long