SATO M-8485Se - Bar Codes

Section 5. Pro
g
rammin
g
Reference
OPPOSITE HAND MODELS
The standard “Se” print engine is referred to as a “right-hand” printer (i.e., when
facing the Control Panel, the label comes out from left to right). The M-8485Se,
M-8460Se and M-8490Se are also available in a “left-hand” (i.e., the labels comes out
right to left) version. The M-8459Se is only available in the standard Right-Hand
confi
g
uation.
Mountin
g
Plate
Label
Label
Ri
g
ht Hand Printer
H = 0001
Left Hand Printer
The only difference in the print area is the horizontal base reference point for the label.
With the standard “Se” printer, the reference point is the first print position nearest the
inside frame. With the “left-hand” version, the reference point is the first print position
away from the frame. The same command stream sent to both printers should print an
identical label except the image may be shifted because of the relative positioning of
the
label under the
p
rint head.
SATO “Se” Print En
g
ines Pa
g
e 5-9