SATO M-8485Se - ADJUSTING THE LABEL SENSOR

Section 2. Installation
ADJUSTING THE LABEL SENSOR
The “Se” printers can position labels using eithe
r
a label gap (transmissive) or an
Eye-Mark
(reflective) sensor. The sensor used is selected by DSW2-2. The gap sensor
position can be adjusted over a limited range. In addition, the signals from the
sensors can be adjusted using the LCD panel to compensate for different liner
opacities and/or Eye-Mark reflectance values.
Print Head
Maximum Width
Maximum Print Width
Ga
p
Sensor
A
d
j
ustment
Non-Printable
A
rea
I-Mark on Back Side of Liner
Minimum Width = 0.125"
(
3 mm
)
Minimum Len
g
th = 0.5"
(
12 mm
)
Max Label Width
(
includes liner
)
M-8459Se M-8460
/
8465Se M-8485Se M-8490Se
5.27"
(
134 mm
)
6.5“
(
165 mm
)
5.27"
(
134 mm
)
5.27"
(
134 mm
)
Max Print Width 4.4"
(
112 mm
)
6.0"
(
152 mm
)
5.0"
(
128 mm
)
4.4"
(
112 mm
)
Gap Sensor
A
d
j
ustment Ran
g
e
0.5" to 2.67"
14 mm to 68 mm
0.5" to 3.25"
14 mm to 82 mm
0.5" to 2.67"
14 mm to 68 mm
0.5" to 2.67"
14 mm to 68 mm
)
Non-Print
A
rea 0.12" (3 mm) 0.12" or 0.25"
3 mm or 6.5 mm
0.12"
(
3 mm
)
0.12"
(
3 mm
)
SATO “Se” Print En
g
ines Pa
g
e 2-9