SATO M-8485Se - Page 28

Section 2. Installation
ADJUSTING SENSOR POSITION
The label gap (transmissive) sensor can be positioned over a limited . The movable
sensor assembly is mounted on the Label Hold Down and is held in position by two
screws. To adjust the position of the sensor, both screws must be loosened and the
sensor moved to the desired position in the slot, and then the screws retightened.
Ad
j
ustments to com
p
ensate fo
r
different line
r
o
p
acit
y
is done with the LCD
p
anel.
Sensor
A
djust
Slot
Print Head
(
shown o
p
en
)
Sensor Position
Screws
Pa
g
e 2-10 SATO “Se” Print En
g
ines