Section 3. Confi
uration
DEFAULT SETTING MODE
Occassionally
it
is
desirable
to
reset
all
printer
configuration
settings
to
their
original
default
conditions.
This
allows the operator
to
start
reconfiguration
of
the
printer
startin
from
a
kno
set
of
conditions.
05.A4.01.02
INITIALIZING
Dis
la
s the firmware durin
the initialization.
DEFAULT SETTING
YES NO
DEFAULT SETTING
COMPLETED
You enter the Default Setting Mode by pressing the LINE and
FEED keys while simultaneously powering the printer on. The
printer will emit one long beep after which the FEED and LINE
keys should be released.
1. Use LINE key to select either the YES or NO.
2. Once the desired setting is selected, pressing the FEED
key will accept the selection and the printer will reset to the
original default conditions.
3. When the printer has completed the reset process it will
beep 3 times and the Default Setting Completed display will
appear. At this time the printer is in the default
configuration.
4. To exit the Default Setting Mode, power the printer off and
then back on.
CLEAR NON-STANDARD PROTOCOL
The
standard
protocol
codes
used
by
the
printer
can
be
modified
to
accomodate
the
requirements
of
different
host
systems.
However,
if
the
printer
is
to
be
used
with
a
system
that
does
not
use
the
custom
protocol
codes,
they
can
be
cleared
and
the
default
protocol
codes
reactivated.
The
default
values
are:
STX
=
7
B
H
,
E
T
X
=
7
D
H
,
E
S
C
=
5
E
H
,
E
N
Q
=
4
0
H
, N
U
L
L = 7
E
H
, C
A
N = 2
1
H
and
OFFLINE
=
5
D
H
.
05.00.03.00
INITIALIZING
Dis
la
s the firmware durin
the initialization.
ALT.PROTOCOL
DEFAULT COMPLETE
To Clear Non-Standard protocol codes, DSW2-7 is placed in
the On position and the printer powered on while
simultaneously pressing the LINE and FEED keys.
1. The printer will emit one long beep at which time the LINE
and FEED keys should be released.
2. When the keys are released, the printer will replace the
Alternate protocol codes with the default values.
3. After the default setting is complete, the printer will emit two
short beeps indicating the process is complete.
4. To exit the mode
ower the
rinter off and then back on.
Pa
e 3-28 SATO
“Se”
Print En
ines
To Next Page
Loading...
