SATO M-8485Se - Card Mode

CARD MODE
The Card Mode allows the operator to manage the Expanded Memory (PCMCIA Card
or Internal Ex
p
anded Flash ROM
)
.
V
05.A4.01.02
INITIALIZING
Dis
p
la
y
s the firmware durin
g
the initialization.
ADVANCED MODE
The Card Mode is entered from the Advanced Mode display
by
pressing
the
LINE
key
once.
CARD MODE
The Card Mode display indicates that the printer is in the Card
Mode. To advance to the first selection,
p
ress the FEED ke
y
.
MEM SELECT (CC1)
CARD MEMORY
CARD->MEMORYCOPY
TRUETYPEFONT Y/N
COPY START
YES NO
TRUETYPEFONTCOPY
COPYING
This selection determines which type of optional expanded
memory will be addressed as
“CC1" in the command
streams.The CARD selection specifies the optional PCMCIA
card as CC1 and the optional Expanded Flash ROM as CC2.
The Memory selection specifies the optional Expanded Flash
ROM as CC1 and the optional PCMCIA card as CC2.
1. Step the cursor to the desired selection using the LINE key.
2. Once the cursor is positioned over the desired selection,
press the FEED key to accept the selection and advance
the display.
This selection allows you to copy TrueType fonts from the
PCMCIA Memory card installed in the Memory Card slot on
the rear of the printer to the optional Flash ROM.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the
Card Copy mode.
If No is selected, the display will advance to the Card to
Memory SATO Font Copy mode.
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
3. Press the FEED key to accept the selection. If Yes was
selected the co
py
p
rocess will start.
TRUETYPE FONTCOPY
COMPLETED
4. Once the copy process is completed, press the FEED key
to ste
p
the dis
p
la
y
.
CARD COPY/FORMAT
XXXXXX
X
ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient
memor
y
available.
SATO
“Se” Print En
g
ines Pa
g
e 3-17