SATO M-8485Se - Page 48

Section 3. Confi
g
uration
CARD->MEMORYCOPY
SATOFONT Y/N
COPY START
YES NO
SATO FONT COPY
COPYING
This selection allows you to copy SATO fonts from the
PCMCIA Memory card installed in the Memory Card slot on
the rear of the printer to the optional Flash ROM.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the
printer will enter the Card Copy mode.
If No is selected, the display will advance to the Card to
Memory Copy All mode.
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
3. Press the FEED key to accept the selection. If Yes was
selected the co
py
p
rocess will start
SATO FONT COPY
COMPLETED
4. Once the copy process is completed, press the FEED key
to ste
p
the dis
p
la
y
.
CARD COPY/FORMAT
XXXXXXX ERROR
CARD->MEMORYCOPY
ALL Y/N
COPY START
YES NO
CARD->MEMORY
COPYING
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient
memory available.
This selection allows you to copy the entire contents from the
PCMCIA Memory card installed in the Memory Card slot on
the rear of the printer to the optional internal Expanded
Memory.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will
enter the Card Copy mode.
If No is selected, the display will advance to the Card to
Memory Copy All mode.
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
3. Press the FEED key to accept the selection. If Yes was
selected the co
py
p
rocess will start
CARD-.MEMORY
COMPLETED
4. Once the copy process is completed, press the FEED key
to ste
p
the dis
p
la
y
.
CARD COPY/FORMAT
XXXXXXX ERROR
MEMORY->CARDCOPY
ALL <0MB>
Y
/N
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient
memory available.
This selection allows you to copy the entire contents of the
optional Expanded Memory to the PCMCIA Memory card
installed in the Memory Card slot on the rear of the printer.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter
the Card Copy mode.
If No is selected, the display will advance to the Card to
Memor
y
Co
p
y
A
ll mode.
Pa
g
e 3-18 SATO “Se” Print En
g
ines