SATO M-8485Se - Command Default Settings

Section 5. Pro
g
rammin
g
Reference
Original
Base
Reference
Point
H = 200
Label Feed
Direction
V = 800
“%1”
COMMAND DEFAULT SETTINGS
There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a “default” value is
assumed.
The commands and the corresponding default values are:
COMMAND DEFAULT NOTE
Print Rotation
0° (1)
Vertical Reference Point
0 (1)
Horizontal Reference Point
0 (1)
Character Pitch
2 (1)
Base Reference Point H=1, V=1 (2)
Character Expansion
1 (1)
Print Darkness
2 (1)
Print Darkness (M-8459Se)
3 (1)
Print Speed 6 ips (2)
Print Speed (M-8459Se) 4 ips (2)
NOTES:
(1) The settings for these commands will revert to the default value when the printer
receives an <ESC>Z or an <ESC>* .
(2) These values transmitted with these commands will remain in effect until a new
command is received.
Pa
g
e 5-8 SATO “Se” Print En
g
ines