SATO M-8485Se - Section 4. Cleaning and Maintenance; INTRODUCTION; ADJUSTING THE PRINT QUALITY

Section 3. Confi
g
uration
DOWNLOAD USER DEFINED PROTOCOL CODES
The user can define a set of custom protocol codes and download them to the printer
usin
g
the <ESC>LD command.
V
05.A4.01.02
INITIALIZING
Dis
p
la
y
s the firmware durin
g
the initialization.
USER DOWNLOAD
PRESS THE LINE KEY
USER DOWNLOAD
WAITING
To enter the User Download mode, DSW2-7 is placed in the
on position and the printer is powered on while simultaneously
pressing the LINE key. The printer will emit one long beep
after which the LINE key is released.
1. Set DSW2-7 Off to replace the Standard protocol codes
or
On to replace the Alternate set of protocol codes.
2. Press the LINE key. The printer is now waiting for the data
to be sent.
3. Transmit the download data command stream to the printer.
4. After the data has been received, the printer will beep and
print a status label. If it does not beep and print a status
label, the printer did not accept the data.
5. If the printer did not beep and print
a status label, turn the
printer off and check your data stream for errors and start
the download process over.
6. If the custom codes are correct, press the FEED key to
accept them and terminate the download process. If they
are incorrect, turn the printer off without pressing the FEED
ke
y
and be
g
in the
p
rocess a
g
ain.
SATO
“Se” Print En
g
ines Pa
g
e 3-29