SATO M-8485Se - Page 49

Section 3. Confi
g
uration
COPY START
YES NO
MEMORY->CARDCOPY
COPYING
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
3. Press the FEED key to accept the selection. If Yes was
selected the co
py
p
rocess will start
MEMORY->CARDCOPY
COMPLETED
4. Once the copy process is completed, press the FEED key
to ste
p
the dis
p
la
y
.
CARD COPY/FORMAT
XXXXXXX ERROR
CARD->MEMORYCOPY
PROGRAM Y/N
COPY START
YES NO
CARD->MEMORY
COPY COPYING
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient
memory available.
This selection allows the user to copy printer firmware from
the PCMCIA Memory Card to the printer.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the
mode
display.
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
3. Press the FEED key to accept the selection. If Yes was
selected the co
py
p
rocess will start
CARD->MEMORYCOPY
COMPLETED
4. Once the copy process is completed, press the FEED key
to ste
p
the dis
p
la
y
.
CARD COPY/FORMAT
XXXXXXX ERROR
MEMORY->CARDCOPY
PROGRAM Y/N
COPY START
YES NO
MEMORY->CARDCOPY
COMPLETED
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient
memory available.
This selection allows the user to copy the current firmware
installed in the printer to a PCMCIA Memory Card.
1. Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance
to the mode
display.
2. Press the FEED key to accept the selection. If Yes was
selected the copy process will start. If you select No, the
display will return to the previous selection.
3. Once the copy process is completed, press the FEED key
to ste
p
the dis
p
la
y
.
SATO
“Se” Print En
g
ines Pa
g
e 3-19