Section 3. Confi
uration
PRINT OFFSET
:+0000 H:+0000
Vertical Offset is the distance down from the leading edge (the
edge of the label that comes out of the printer first) to the first
vertical print position. A positive setting moves the label edge
out of the printer while making it negative moves it bsack into
the printer.
Horizontal Offset is distance that the label image is
shifted either to the right or left on the label. The image is
shifted to the left (towards the inside edge of the label) for a
positive setting and it is shifted to the right (towards the
outside edge of the label)
for a negative setting. This setting
changes the base reference point for all subsequent label
jobs.
It’s
effect is identical to the <ESC>A3 Base Reference
point command. Since the printer moves the label in discrete
steps equal to the size of the print dot, the units of measure for
Vertical and Horizontal Offset distance is dots. The maximum
values that can be set for each is +
-800.
1. Use the LINE key to step the counter to the desired setting.
The display will increment one step for each time the LINE
key is pressed. If the LINE key is held pressed for more
than two seconds, it will automatically go into the fast scroll
mode. The reading
will advance to the maximum setting of
800 after which it will automatically wrap and start at
“000”
a
ain. The ran
e
2. Once the setting is correct, pressing the FEED key will
accept the setting and advance to the next display.
Note: This setting can be overriden by the Base Reference
Point Comman
.
HEAD DOT DENSITY
100 150 3
00
CALENDAR CHECK
YES N
O
This selection only appears on the M-8490Se and M-8465Se
when the DSW2-8 = On, and a 300dpi print head has been
installed. It allows the user to select the print density.
1. Use the LINE key to step the underline cursor to the desired
selection.
2. Once the underline cursor is under the desired selection,
pressing the FEED key will
accept the setting and advance
the display
If the optional calender chip has been installed in the printer,
this menu appears. The default is No.
Similarly, the Set Calendar appears (if the chip is installed)
allowing the date and time to be set manually using the LCD
Display or via the <ESC>WT Calendar Set command. The
last setting, set either manually via software command,
received by the printer will be the value used. The format of
the display is YY/MM/DD hh:mm
(Year/Month/Day/hours:minutes).The date format is fixed and
cannot be changed.
To set the Calendar, press the LINE key until the cursor is
over YES. If the Calendar feature is to be disabled, press the
LINE key until the cursor is underneath NO. When the desired
setting is selected, press the FEED key.
Pa
e 3-14 SATO
“Se”
Print En
ines
SET CALENDAR
YES N
O
To Next Page
Loading...
