CANCEL PRINT JOB
YES N
O
CANCEL PRINT JOB
CURRENT A
LL
If the printer has a print job(s) in memory, selecting
YES will cause the job(s) to be cleared. The default
selection is NO. Be sure you want to cancel the print
job(s) before selecting yes as the job(s) cannot be
recovered and will have to be retransmitted tyo the
printer.
1. Use the LINE key to step the cursor to either the YES
or NO selection.
2. Next, you can select Current to cancel the current
print job. If not print job is currently in process, the
next print job will be cancelled. Selecting ALL
cancels all queued print jobs (if any).
3. Once the correct setting is selected, pressing the
FEED key will accept the setting.
4. After the print job(s) have been cleared from
memory, the printer will display a COMPLETED
message for 3 seconds and then return to the initial
ONLINE Normal Mode.
5. If you wish to change any of the settings, you
must enter the User Settings mode again by
taking the printer
OFFLINE and pressing the
LINE and FEED keys.
SEND BACK DAT
ES NO
This function is valid when the printer buffer has been set
to operate on a single-item basis, where each print job is
processed one at a time. DSW2-5 must be set to ON for
this mode.
Use the LINE key to select YES or NO (default), followed
by pressing the FEED key to confirm the selection.
If this function is set to YES, then the printer will, in the
event of a printing error and taken OFFLINE, send back
the most recent print job data processed/printed, back to
the host for verification. This is useful for diagnosing
programming errors. When data sendback happens, the
TRANSMITTING message appears, followed by a
COMPLETED message upon successful sending of the
print job data back to the host computer.
SEND BACK DAT
TRANSMITTING
SEND BACK DAT
COMPLETED
CANCEL PRINT JOB
COMPLETED
Pa
e 3-12 SATO
“Se”
Print En
ines
To Next Page
Loading...
