SATO M-8485Se - Page 38

Section 3. Confi
g
uration
2.
Press the LINE ke
y
to place the printe
r
in the Off Line status.
3. Press the FEED ke
y
to feed out a blank label.
4. Adjust the position using the OFFSET potentiometer on the front control panel
and feed another label by depressing the FEED key. Repeat this procedure until
the label is full
y
released from the liner.
DISPLAY
This potentiometer is used to adjust the contrast of the LCD display for optimum
viewin
g
under various li
g
htin
g
conditions.
PRINT
The PRINT potentiometer is used to adjust the amount of heat (i.e., power) applied to
the head for printing. It provides a continuous range of adjustment. Maximum print
darkness is obtained by turning the potentiometer all the way clockwise and a
maximum counterclockwise settin
g
will
g
ive the li
g
htest
p
rint.
NOTE: The PRINT potentiometer adjustment will affect the darkness in all of the
comman
d
code s
p
ee
d
an
d
darknes
s
ran
g
es.
Pa
g
e 3-8 SATO “Se” Print En
g
ines