SATO M-8485Se - Page 106

Appendi
x
A: Optional Accessories
2. Remove the two Interface Module Retainin
g
Screws .
3.
Gras
p
the Interface Module and
p
ull it out of the connector.
4.
Place the new Interface Module in the slot and press inward firmly until it is
p
ro
p
erl
y
seated.
5.
Re
p
lace the two Interface Card Retainin
g
Screws .
6.
If the new Interface Module is for a serial interface, set DSW1 for the proper
o
p
eration.
7.
Connect the interface cable to the connector.
SATO “Se” Print En
g
ines Pa
g
e
A
-3