SATO M-8485Se - Section 2. Installation; INTRODUCTION; INSTALLATION

SECTION 2
INSTALLATION
INTRODUCTION
This section of the manual has been written to help you install the SATO “Se” print
en
g
ine modules and to
g
et started as
q
uickl
y
as
p
ossible.
It is recommend to read each chapter in this manual before the installation or the use
of the
p
rint modules.
INSTALLATION
Careful consideration must be given when selecting the location of the printer,
especially to environmental considerations. To obtain optimum results from the SATO
“S”
p
rint module
,
alwa
y
s tr
y
to avoid o
p
eration locations influenced b
y
:
• Direct or bright sunlight, as this will make the label sensor less responsive
and may cause the label to be sensed incorrectly.
• Locations which have extremes of temperature, as this can create electrical
problems on the circuits within the printer.
• The installed location of the printer should ideally be in areas free from
dust, humidity and sudden vibrations.
CONSUMABLES
Always use SATO carbon ribbons or equivalent in the thermal transfer models.
The use of incorrect materials may cause malfunctions of the printer and void the
warrant
y
.
SATO “Se” Print Engines Page 2-1