SATO M-8485Se - Page 34

Section 3. Confi
g
uration
Backfeed Sequence (DSW3-1) . Backfeed is used to correctly position the label for
application and then retract the next label to the proper print position. This operation
can be performed immediately after a label is printed and used, or immediately prior
to the
p
rintin
g
of the next label.
DSW3-1 SETTING
ON
OFF
DSW3
1 2 3 4 5 6 7 8
Label Sensor Selection (DSW3-3) . Enables or disables the Label Sensor. If the
Sensor is enabled, it will detect the edge of the label and position it automatically. If
it is disabled, the positioning must be under software control using Line Feed
commands.
DSW3-3 SETTING
ON
OFF
DSW3
1 2 3 4 5 6 7 8
Back-Feed Selection (DSW3-4) . When Back-Feed is enabled, the printer will
position the last printed label for dispensing and retract it before printing the next
label. The amount of backfeed offset is ad
j
ustable .
DSW3-4 SETTING
Off Enabled
ON
OFF
DSW3
On Disabled
1 2 3 4 5 6 7 8
External Signal Interface . See Section 6: Interface Specifications for information
EXT Print Start Signal Selection (DSW3-5) . Allows an external device to
initiate a label print for synchronization with the applicator. See Section 6: Interface
Specifications for a description of the signal level and requirements When DSW3-5 is
On, the unit is in the Continuous print mode, Backfeed is disabled and External
Si
g
nals are i
g
nored.
DSW3-5 SETTING
ON
OFF
DSW3
1 2 3 4 5 6 7 8
Pa
g
e 3-4 SATO “Se” Print En
g
ines
Off Before
On
After
Off Enabled
On
Disabled
Off Sensor Used
On Not Used