SATO M-8485Se - Page 56

COUNTERS MODE
The Counters Mode is provided to allow the user to access the internal printer
cousters.
Section 3. Confi
g
uration
ADVANCED MODE
The Counter Mode is accessed from the Advanced Mode.
Press
the
LINE
key
to
step
to
the
Counter
Mode.
COUNTERS MODE
Pressing the FEED key will advance the display to the counter
selections.
COUNTERS
HD DSP CUT LIFE
HEAD COUNTER
0.5M
HEAD COUNT CLEAR
YES NO
The counters are identified in the displa
y
as:
HD:Head Counter (should be reset when print head is
replaced)
DSP: Dispense Counter (not used on
“Se” printers)
CUT: Cutter Counter (not used on
“Se” printers)
LIFE: Life Counter (cannot be reset)
1. Use the LINE key to step the cursor to the desired counter,
the Head (HD) counter or the LIFE counter. The default
position is the Head Counter. Use the LINE key to advance
the cursor to the desired selection.
2. Once the correct setting is selected, pressing the FEED key
will display the current value (in meters) stored in the
counter. The maximum number of digits displayed is 8.
3. Pressing the FEED key again will advance the counter to
the Clear mode. All counters with the exception of the
LIFE
counter may be cleared.
4. Use the LINE key to select the desired setting. If you only
wanted to read the counter value, select NO. If you want to
read the counter and reset it to 0.0, place the cursor over
the YES. Once the desired setting is selected, pressing the
FEED key will advance
the return you to the Counters Mode
display.
COUNTERS MODE
5. To exit the Counters Mode, turn power to the printer off and
then
back
on.
Pa
g
e 3-26 SATO “Se” Print En
g
ines
RFID MODE
The basic RFID Mode in the standard firmware allows the operator to set the
printer to use an optional RFID kit. A special firmware with more RFID functions
is needed for more advanced RFID implementations. Check with your dealer.
RFID MODE
The RFID Mode is entered from the Advanced Mode display
after cycling through th
e Counters Mode.
RFID MODULATION
Press the FEED key repeatedly to select either 10% (default)
or 100% modulation levels, the press the LINE key to confirm
the selection. A higher modulation level results in higher
accuracy and detection speeds at the expense of interference
levels. Pressing the FEED key returns the user to the
Advanced Mode menu.
ADVANCED MODE
1
0% 100%