SATO M-8485Se - Page 72

Section 5. Pro
g
rammin
g
Reference
Mounting
Plate
Base Reference
Point, H=0001
Mounting
Plate
Base Reference
Point, H=0001
Label
Label
5"
2"
Left-Hand Printe
r
The Command Code subsection contains a sample label output for each command
code. These samples reflect how the printed information would appear on a five inch
wide label (see illustration). If you want to test any of the sample label outputs and
are using labels less than five inches in width, you will have to adjust the positioning
accordin
g
l
y
so that the
p
rinte
r
does not tr
y
to
p
rint where there is no label.
You must be careful not to print off the label surface as the label provides a heat sink
for the print head elements. Doing so will cause irreparable damage to the head. This
dama
g
e is not covered under the
p
rint head warrant
y
.
For example, the following illustrates a sample data stream and the resulting label
assumin
g
a five inch wide label on a left-hand model
p
rinter:
<ESC>
A
<ESC>H0050<ESC>V0100<ESC>L0303<ESC>MSATO
<ESC>H0050<ESC>V0200<ESC>B103100*SATO*
<ESC>Q1<ESC>Z
If you are using a two inch wide label, the entire image may not appear on your label.
B
y
addin
g
the followin
g
Base Reference Point command to the second line of the data
H=50
V=100
SATO
V=200
*SATO*
*SATO*
*SATO*
2"
5"
Unshifted Print
A
rea
Pa
g
e 5-6 SATO “Se” Print En
g
ines