SATO M-8485Se - Page 88

Section 6. Interface Specifications
BYTE
NUMBER
HE
X
V
ALUE
DESCRIPTION
9 00 Print Densit
y
Level 1
01
02
03
04
10 00
01
02
11 00
01
Print Densit
y
Level 2
Print Density Level 3
Print Density Level 4
Print Density Level 5
Reflective (Eye-Mark) Sensor
Gap (See-Thru) Sensor
No Sensor
Zero Slash Disabled
Zero Slash Enabled
12 00 Reserved
13 00
01
14 00
01
15 00
01
16-17 00 to C80
00 to 12C0
18-19 00 to 340
00 to 4E0
20-21 00 to 3E7
FFFF to FC19
22-23 00 to 320
00 to FCE0
24 00 to 63
FF to 9D
25 00 to 63
FF to 9D
26 00 to 63
FF to 9D
27 00 to 63
FF to 9D
28 00
01
Not Supported
Not Supported
Online Feed Disabled
Online Feed Enabled
Fixed Pitch
Proportional Pitch
Not Supported
Not Supported
Vertical Base Reference Point Offset in dots (0 to 792)
Vertical Base Reference Point Offset in dots (-1 to -792)
Horizontal Base Reference Point Offset in dots (0 to 800)
Horizontal Base Reference Point Offset in dots (-1 to
-800)
Not Supported
Not Supported
Not Supported
Dispense Offset in dots (0 to 99)
Dispense Offset in dots (-1 to -99)
Compatibility Mode Enabled
Compatibility Mode Disabled
29 08 to 40 Not Su
pp
orted
30 00
01
Buzzer Enabled
Buzzer Disabled
Pa
g
e 6-12 SATO “Se” Print En
g
ines