SATO M-8485Se - Page 92

Section 6. Interface Specifications
Font Confi
g
uration
(
SOH + FG
)
Upon Receipt of an SOH (hexadecimal 01) followed immediately by an ASCII FG
causes the printer to return a 102 byte Font/Graphics Status Word bounded by an
STX-ET
X
p
air that re
p
orts information on the stored font or
g
ra
p
hic.
Note: The printer must be in the Font/Graphic Download (See Section 3:
Confi
g
uration
)
mode before a res
p
onse wil
l
be received.
BYTE
NUMBER
V
ALUE DESCRIPTION
1-2
A
SCII Font ID Number
3-4 00
H
01
H
Font
Graphic
5-36
A
SCII Font Name
37-48 ASCII Font Style
49-52 ASCII Font Point Size
53-54 Hex Character Width in dots
54-60 Hex Character Height in dots
57-60 Hex Font Size
58-64 Hex Font Registration Number
65-68 Hex Font Data Top Address
69-72 Hex Total Size
73-74 Hex Vertical/Horizontal Writing Flag
75 Hex Character Pitch, Fixed/Variable
76 Hex Family Attribute
77 Hex Character Set
78 Hex Italic Attribute
79-80 Hex Weight Attribute
81-82 Hex Spread
83-84 Hex Assent in dots
85-86 Hex Registration Start Code
86-87 Hex Registration End Code
88-95 Hex Reserved
96-98 Hex Code
99-100 Hex Horizontal Valid Size
101-102 Hex Left Gap Size
Pa
g
e 6-16 SATO “Se” Print En
g
ines