SATO WS4 Series - Parameter Setting - Sensor and Feed Key Configuration; Parameter Setting - Head Check and Calibration

6 SATO WS4 Printer Utility Work with SATO WS4 Printer Utility
58
Property Name
Description
Sensor Type
It is the media sensor you are using. It includes I-MARK,
GAP and None. When you perform media calibration, the
sensor is set to the one you select.
Ribbon Sensor
Thermal Transfer Your printer uses the ribbon sensor to
detect the ribbon, it is mean Thermal Transfer (TT).
Direct Thermal Disable the ribbon sensor, it is mean
Direct Thermal (DT).
Feed Key
It defines the action of the FEED button.
Feed Your printer feeds a blank label each time the
button is pressed.
Reprint Your printer reprints the last label each time the
button is pressed.
Head Check(Power
on)
Enable Your printer checks broken pins on the printhead
automatically once your printer is turned on.
Disable Disable the auto head check.
Auto Calibration
ON (Power on) Your printer automatically calibrates
media using a media sensor once it restarts or is turned on.
ON (Head close) Your printer automatically calibrates
media using a media sensor every time you close the print
module when the printer is turned on.