SATO WS4 Series - Parameter Setting - Print Control and Offsets; Parameter Setting - Unit and Status Settings

6 SATO WS4 Printer Utility Work with SATO WS4 Printer Utility
59
Property Name
Description
ON (Power on and Head close) Your printer
automatically calibrates media using a media sensor after
power on and every time you close the print module when
the printer is turned on.
OFF You need to manually calibrate media using a media
sensor as you change the media, or your printer won’t
work properly.
Reprint After Error
Enable Your printer when caused by the error condition.
The label is reprinted as soon as the error condition is
corrected.
Disable Disable the reprint after error.
Print Darkness
Adjust the darkness relative to the current darkness
setting. The range is +1~ +5, and the value is adjustable in
increments of ± 1.
Print Speed
Determine the media speed during printing. The range is
+2 ~ +6, and the value is adjustable in increments of ± 1 ips.
Stop Position for
Cutter
Blank Printer does not install cutter module.
Head Position Stop the paper forward on the head
position.
Cutter Position Stop the paper forward on the cutter
position.
Stop Position for
Dispenser
Blank Printer does not install dispenser module.
Head Position Stop the paper forward on the head
position.
Dispense Position Stop the paper forward on the
dispenser position.
Tear Off Wait Time
Your printer moves the paper forward in a predefined time
after printing, and pulls the paper back in a predefined
length once the printing begins again.
Zero Slash
Display a zero with or without a slash through it.
Unit(Label)
mm Change the unit of label to millimeter.
inch Change the unit of label to inch.
Width
Set the print width.
Height
Set the length of the label when using continuous media.
Unit (Position
Adjustment)
mm Change the unit of Position Adjustment to
millimeter.