SATO WS412DT - Page 13

9
5) Response to the print command
This information applies only when using the RS232C interface and STATUS4 (Protocol for driver).The print job will
start by receiving the print command (STX ESC+“A”~ESC+“Z” ETX).
The printer status after completing this process is returned.
(1) List of return status
Return status
Description
ACK(HEX 06H)
No error in the printer
NAK(HEX 15H)
Error in the printer
Example of Job ID Number command
* Note
For the Job ID Number command, refer to the Command Specifications.
<A>
<ID>01
<V>100<H>100<P>2<L>0202<XM>ABC
<Q>1
<Z>