Scan-Electronics RadiaCode-101

To Next Page

To Previous Page

Standalone usage 27

select [Sound] item by short pressing the

swing buttons;

select [On] or [Off] variant, according to the

desired action, by short pressing the round

button.

To change the vibration permission (while in the [Buttons]):

select [Vibro] item by short pressing the swing

buttons;

select [On] or [Off] variant, according to the

desired action, by short pressing the round

button.

To return to the higher level or quit the menu, set focus on the [<Back] or [<< Menu quit] item

respectively and confirm your choice by short pressing the round button.

If you need to change the separate permissions for alarms signaling, take the following steps (while in

the [Signals]):

set focus on the [Alarms] item by short pressing the "up" and "down"

swing buttons;

enter the submenu by short pressing the round button.

To change the sound and vibration permissions of the dose rate alarms (while in the [Alarms]):

set focus on the [Dose rate] item by short pressing the "up" and "down"

swing buttons;

enter the submenu by short pressing the round button.

To change the sound and vibration permissions of the accumulated dose alarms (while in the

[Alarms]):

set focus on the [Dose] item by short pressing the "up" and "down" swing

buttons;

enter the submenu by short pressing the round button.

Next steps are identical for [Dose rate] and [Dose] settings:

Scan-Electronics RadiaCode-101 - Page 29