Scantech-ID VEGA Area Imager 21
ATTENTION
The VEGA scanner must be charged for a minimum of 8 hours
before the scanner can be placed in full operation for the first time.
The cradle red led will indicate in red when the scanner is charged.
After the battery is full, the red light will be off.
If the battery power of the VEGA is too low, the VEGA will indicate
this with red led and beeper warning.
It is important to know that the VEGA scanner will only communicate with the
cradle whose unique Bluetooth MAC address was the last address scanned.
If a cradle is paired with the VEGA scanner, another VEGA scanner can’t be
paired with that cradle until the original connection is broken.
If you pair a second VEGA scanner to an in use cradle, the cradle’s connection to
the first VEGA scanner will be broken and the connection re-established with the
second VEGA scanner.
FCC ID : WOI-0852202T1000
To Next Page
Loading...
