22 Installation of the VEGA V-1020BT
4.3.3 Set up Server Mode Communication
To set-up the communication between the
VEGA scanner and Bluetooth
application device follow the next steps.
1. The VEGA scanner must scan “Scanner Server Mode ON/Scanner Client
Mode Off” barcode , to set the VEGA scanner in server mode.
2. When control the Bluetooth device to search the scanner, enter pin code
(default 00:00:00:00) to setup comport.
3. When VEGA scanner is successful connected, scanner will initiate with
short beep sounds. Blue and red led will also blink followed by a long
beep sound. Blue led will turn off to finish the set up.
4.3.4 Sleep mode
The VEGA scanner is equipped with sleep mode function to save battery energy,
when the VEGA scanner is not used for a specified time. During sleep mode all
the functions and connection will be halted, After press the red trigger button
the scanner can be wake up and reconnect the communication with the cradle.
The waiting time to go into sleep mode can be set into 1 minute or 10 minutes by
scanning the according programming code, see chapter 7.
4.3.5 Memory mode
This memory mode function is enabled when the Bluetooth connection fail and you
have scanned data. This data is stored in the memory of the VEGA scanner.
When scan barcode “memory read” stored data will be immediately transmit to
the cradle after reconnection, when scan barcode “memory clear” all stored
memory data will be erased.
The capacity of this memory depends on the scanned data size, approximately 50
sets of data.
This function is not operational when there is successful Bluetooth connection.
To Next Page
Loading...
