Operation
BASO 1 MS - 02.04 - V02 Page 4-7
4.5 Operating instructions for special machines
The following instructions apply only to machines with fresh water and waste water tanks.
4.5.1 Filling the fresh water tank
If the water level in the fresh water tank is too low, the [
] button will flash. The
display shows:
1. Remove the fresh water tank.
2. Fill it with fresh water.
3. Return the water tank to its correct position.
4. Press the red flashing [
] button to confirm.
To ensure that the water pump does not run dry, the product selection option is dis-
abled when the level in the water tank is too low.
4.5.2 Emptying the waste water tank
The [
] button flashes when the waste water tank is full. The display shows:
1. Remove the waste water tank.
2. Empty the water tank and rinse it out.
3. Return the waste water tank to its correct position.
4. Press the red flashing [
] button to confirm.
To prevent the waste water tank from overflowing, the product
selection option is disabled.
4.5.3 Operating instructions for appliances with fresh and waste water tanks (on trolleys)
• Capacity:
- freshwater tank - 16 litres
- waste water tank - 11 litres
• The fresh water tank must be filled with clean, fresh drinking water every day.
• If the machine is not used for some time, both tanks must be emptied and
cleaned.
• The interior of the trolley must be kept dry at all times.
• The two tanks must only be used when they are correctly positioned (level moni-
toring).
• For safety reasons, pull the trolley from place to place - do not push it.
• The trolley is not intended for the transport of goods. M. SCHAERER Ltd. does
not accept liability for damage that occurs because the trolley is handled incor-
rectly or because the instructions in the manual have not been followed.
product blocked
waste water full
product blocked
water tank empty
To Next Page
Loading...
Need help?
General
