Operation
Page 4-8 BASO 1 MS - 02.04 - V02
4.5.4 Ambiente with side-mounted fresh water tank
The following is displayed each time the machine is switched on and before it is
cleaned:
1. Remove the water tank.
2. Fill it with fresh water and replace it.
3. Empty the drip tray, clean it and replace it.
4. Press the flashing [
] button to confirm.
If there is insufficient water for the product ordered, the machine switches off
and the display shows:
Carry out steps 1 to 4.
5. Re-order the product.
Pressing a product button several times fills the pipework with water. Take care
if accounting mode is active, e.g. pressing the cleaning button.
The capacity of the tank is 4.5 litres.
4.5.5 Ending operation / Switching off the coffee machine
If the coffee machine is not going to be used for longer periods, e.g. nights, it should be switched to
stand-by. In this mode, the boilers are not heated and no beverages are available.
1. Do the daily cleaning (see Chapter 5 "Daily cleaning").
2. Briefly press the [ ] button; the display will go dark.
The following message is displayed:
4.6 Extended idle times
4.6.1 Extended idle time of up to 4 weeks (e.g. holiday close-down)
1. Do the weekly cleaning (see chapter 5 "Weekly cleaning").
2. Set the machine first into stand-by mode: see chapter
4.5.5, "Ending operation /
Switching off the coffee machine" page
4-8.
3. Close the fresh water supply tap.
4. Turn off the main switch, or disconnect the power supply (unplug).
5. Vacuum the coffee beans out of the containers.
6. On premises where the temperature can drop below zero, the boilers must be
emptied. To empty the boilers, ask a customer service authorized by the manu-
facturer for assistance.
If you resume operation at later point in time, ensure that you open the water sup-
ply first and only then switch on the power supply.
<< Standby >>
water tank empty
water tank full ?
To Next Page
Loading...
Need help?
General
