Schenker SMART 100 User Manual

5 – FUNCTIONING AND USE COD.100S12/24.D.2018
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
32
This function activates automatically the first start up procedure. The procedure is necessary when a new
machine is started for the first time, or after the filter cartridge replacement, or a general service. The
procedure allows to purge completely the air from the system, and from the seawater and the washing fresh
water hoses. The depressurization valve must be opened before start the procedure.
• PERIODIC WASHING
This function allows a periodic automatic rinsing (every 6 up to 10 days) with fresh water. It can be used
before long inactivity periods. The single washing operation will last about 1 minute. The consumed fresh
water, for every washing, is about 30 liters. Therefore it is suggested to evaluate if the fresh water reservoir
is enough for the programmed cycles. Selecting NO, the function will be disabled.
To activated the function select the days (6 to 10), exit from the menu, pushing STOP, and then push
WASHING for 3 seconds. The display will indicate the remaining day before the first rinsing. The function
is anyway disabled pushing STOP, or after a normal production cycle.
MESSAGES
• SYSTEM STANDBY
It indicates that the system is ready to be set and started.
• TOTAL HOURS
It indicates that the total, progressive working time of the watermakers.
• SYSTEM WASHING
It indicates that the unit is in washing mode (pumps and electrovalve on).
• LOW PRESSURE

Schenker SMART 100 Specifications

General

Brand	Schenker
Model	SMART 100
Category	Water Filtration Systems
Language	English